Mono Crystal Radio Amplifier Board For Headsets, Speakers, Earphones and Cable

Description

Crystal Radio Audio Signal Amplifier For Mono Headset, Speaker or Non-Piezo Magnetic Earphone or Earbud
Allows you to use Non-Piezo Earphone, Speaker or Headsets with your Crystal Radio
For Crystal Radio use: Connect the Radio Audio Output to the Input Terminals of the Amplifier
This Listing is for One Amplifier and One Double Ended Connection Cable
Caution: R
epetitive
flexing
of the wires can
damage any
wire
and
cable
systems.
I
t is a good practice to enclose the Amplifier and speaker inside a project box to minimize flexing of the wires as repeated flexing and bending of the wires will cause pre-mature breaking of the wires.
CONNECTION DETAILS ARE SHOWN IN THE PHOTO GALLERY
Package Includes:
1 piece fully assembled Amplifier Board
1 piece 200mm Long Double Ended Terminal Cable (You can cut off one end)
Perfect for Crystal Radio
Wide Operating Voltage Range: 5-12V
With power indicator LED
Pin connection leads for Input and Power
Package Contents:= 1 Amplifier Board and 1 Cable
Easy to directly connect Audio Output from the Amplifier to your Earphone or a Speaker, to the Terminal Block
10K variable potentiometer so, you can adjust the Amplification Volume
PCB Board Size : 41 x 14mm(L*W)
Very little distortion